1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
3 OF 4
K-RANGE 24
™
24V TUNABLE WHITE LED TAPE LIGHT
®
+
−
Cut points not drawn to scale.
IG082514-1.3
+
−
− −
+
−
Cut points not drawn to scale.
+ +
− −
+
−
Cut points not drawn to scale.
K-RANGE
™
CLICKTIGHT
™
Connectors
Cut the tape at the line indicated with the scissors icon. Close the CLICKTIGHT™ latch to ensure connecon.
When ready for mounng, peel o the 3M™ adhesive backing
of the tape and tear o along the connector tray edge. Mount
tape light and ulize a wiring harness to secure lead wires.
Open the CLICKTIGHT™ latch and note the +/- polarity markings.
Firmly insert the tape light into the connector tray with the
3M™ adhesive backing sll intact to the tape. Ensure the
contact/solder points of the tape are directly underneath the
metal placement tabs of the connector.
These instrucons apply only to K-RANGE™ CLICKTIGHT™ Connectors (does not apply to solid color CLICKTIGHT™ Connectors). Never cut tape aached
to a live circuit.
+
+ +
−
− −
+
−
Cut points not drawn to scale.
Cut points not drawn to scale.
Prior to troubleshoong, ensure all items are a compable system and main power is turned ON.
Troubleshooting
Shi in brightness and/or kelvin
• Review maximum series run limits. Exceeding these limits will cause
excess voltage drop, decreasing brightness and/or kelvin as the run is
extended.
Some LEDs are not funconal
• Ensure all connecons have been properly aached. Ensure xture
has not been bent excessively, which may cause components and sol-
der to detach from the circuit board.
Lights are ickering
• Ensure a compable driver is installed. Ensure the pre-set mode of
the controller is not on a dynamic mode. If lights connue to icker,
check for loose connecons. Ensure tape light connectors are properly
aached.
Lights are turning on/o repeatedly
• Ensure driver is not overloaded. An overloaded driver will trip the in-
ternal auto-reset (of driver) repeatedly, turning the system on/o.
CLICKTIGHT™ Connector Troubleshoong
• Ensure compable CLICKTIGHT™ models are aached. Tape lights vary
in width and require specic connectors. Contact your supplier for
addional informaon.
• Tape light is polarity sensive. Ensure the +/- markings of the CLICKTIGHT™
connector is aligned with the +/- markings of the tape. If polarity is
backwards, reverse the lead wire connecon or detach tape from
CLICKTIGHT™ connector and reaach opposing end of tape to connector.
PW
CW
V+
Wiring Harness
3M™ Adhesive
(2 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce