Diode-led REIGN Button/Full Slide Dimmer Uživatelský manuál Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 3
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
IG051514-1.1
1.877.817.6028
www.DiodeLED.com
INSTALLATION GUIDE
®
[email protected] www.DiodeLED.com
2 OF 3
REIGN™ 12-24V BUTTON/FULL SLIDE DIMMER SWITCH
Install Addional Components, Verify Connecons, and Turn
Main Power ON at Breaker.
6
ON
OFFOFFOFF
ONON
OFFOFF
ONON
If system remains unresponsive or is working improperly, turn OFF
main power at breaker and verify all connecons. Review the ‘Wiring
Connecons’, ‘System Diagrams’, and dimming control installaon guides.
Replace wiring back into wall box. Break o appropriate ns
when ganging mulple dimmers. Screw dimmer and faceplate
to wall box.
5
Never install low and high voltage wiring in the same wall box. A physical
divider must exist when ganging low voltage and high voltage controls.
To detach a n, grip with pliers and bend back/forth unl it detaches.
Unlike high voltage dimmers, de-rang the dimmer maximum load is not
required when ganging low voltage controls.
* Driver may not require a fault ground connecon. Refer to driver
specicaons for addional informaon.
*** Install a Class 2 constant voltage driver compable with a low voltage
PWM controller.
**** No more than one PWM controller/dimmer switch can be aached
to a single output of the driver.
‡ Refer to driver specicaons for a compable juncon box.
‡‡ See xture specicaons for maximum series run limits.
The following diagram is provided as an example system design. Class 2 compliance requires a Class 2 driver per REIGN dimmer (e.g. 60W @ 12V, 96W
@ 24V). Install in accordance with the NEC, and local regulaons.
AC Power
50/60Hz
L
N
V- (Black)
Input
Output
V+ (Red)
G*
N
L
Input
Output
V+
V-
Class 2 Low Voltage Driver****
Installed in Juncon Box
Install applicable wire gauge / type
V+
V-
LED Tape Light / Fixture
‡‡
REIGN 12-24V Dimmer****
Installed in Switch Box
V+
V-
System Diagram
Zobrazit stránku 1
1 2 3

Komentáře k této Příručce

Žádné komentáře