Plug-In Adapter Installaon: Ensure main power is
turned OFF. Aach a ‘Male Wet Locaon to DC Adapter
Connector’ to the spot module and then connect to the
plug-in adapter. Aach addional in-line accessories.
Plug the adapter into a 120VAC receptacle and turn ON
main power.
Magnec Dimmable Driver Installaon: Ensure main
power is turned OFF. Aach a ‘Male Wet Locaon Splice
Cable’ to the spot module or splier cables and hard-
wire to the dimmable driver. Refer to the Magnec Dim-
mable Driver Installaon Guide for more thorough wiring
instrucons.
12/24V REIGN Dimmer Installaon: Ensure main power
is turned OFF. Aach a ‘Male Wet Locaon Splice Cable’
to the spot module or splier cables and hard-wire to the
REIGN Dimmer. Ensure a compable driver is aached
to the dimmer. Refer to the REIGN Dimmer Installaon
Guide for more thorough wiring instrucons.
V-
(Black)
Input
Output
L
N
V+
(Red)
G*
N
L
Input
Output
V+
V-
Class 2 Low Voltage Driver****
Installed in Junction Box
‡
REIGN 12-24V Dimmer****
Wet Location Splice
Cable - Male
Wet Location Splitter Plug
V+
V-
AC Power
50/60Hz
AC Power
50/60Hz
120VAC Magnetic Low
Voltage Dimmer
†
L
N
Dimmable Driver
††
Wet Location Splice
Cable - Male
Wet Location Splitter Plug
V+ (Red)
V- (Blue)
N (White)
L (Black)
Inline Accessory
(Extensions, splitters, controls, etc.)
Class 2 Low Voltage
Plug-In Adapter (Driver)
Insertion points for
DC plug accessories
Wet Location Splitter Plug
Male Wet Location to DC
Adapter Connector
AC Power
50/60Hz
INSTALLATION NOTES (see web page for larger diagrams)
* Driver may not require a fault ground connecon. Refer
to driver specicaons for addional informaon.
**** Determine the number of low voltage outputs of
the driver when installing mulple PWM controllers/dim-
mer switches. No more than one PWM controller/dimmer
switch can be aached to a single output of the driver.
† Install a compable magnec low voltage dimmer
switch. See dimmer switch manufacturer installaon
guide for complete wiring instrucons.
†† Dimmable drivers require a compable magnec low
voltage dimmer switch to supply the driver and xture
with appropriate input voltage. Do not test or install di-
rectly connected to an AC power source or On/O switch.
It is recommended to load the driver no more than 80% its
labeled rang for maximum longevity. See dimmer switch
manufacturer specicaons for minimum load recom-
mendaons.
‡ Refer to driver specicaons for a compable juncon
box.
(2 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce